Econoline E350 1 Ton V8-7.3L DSL Turbo VIN F (1998)
b.
Cut the boss support rib down 12 mm (0.5") from the boss to support rib of the bracket (Figure 2).
c.
Modified bracket should appear as in Figure 3.
3.
Mount the dual arm tensioner onto the alternator mounting bracket and verify that it lies flat on the mounting surface of the bracket.
4.
Reinstall bracket/tensioner assembly, flat idler pulley, and alternator. Install new drive belt The grooved idler is no longer required, discard this
part. Remove old belt routing decal and install new belt routing decal.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage And Powerstroke Diesel Engine Warranty
Coverage
