Econoline E350 1 Ton V8-7.3L DSL Turbo VIN F (1998)
NOTE: Prior to installing the solenoid body assembly, coat the case connector bore with Silicone Brake Caliper Grease and Dielectric
Compound D7AZ-19331-A (Motorcraft WA-10)or equivalent meeting Ford specification ESE-M1C171-A.
8. Install the (A) main control valve body, aligning the (B) manual shift valve with the (C)inner manual valve detent lever. Install the (D) nuts and the
(E) bolts finger-tight.
9. If previously installed, remove, then reinstall, the bolt into the separator plate reinforcing plate.
1. Remove the bolt.
2. Install the bolt.
