Econoline E550 V10-6.8L VIN S (2003)
Material
Removal and Installation
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake
fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately.
1. Disconnect the brake master cylinder fluid level switch.
2. Use a suitable suction device to drain the brake master cylinder reservoir.
3. Carefully pry up on the brake master cylinder reservoir to remove.
4. NOTE: Whenever installing a new brake master cylinder reservoir, install new grommets.
Install the brake master cylinder reservoir.
1. Lubricate the two grommets with clean brake fluid and insert the grommets into the brake master cylinder.
2. Press the brake master cylinder reservoir into the grommets until it is fully seated.
3. Connect the brake master cylinder fluid level switch.
4. Fill the brake master cylinder reservoir with clean brake fluid.
