Econoline E550 V10-6.8L VIN S (2003)
Brake Light Switch: Service and Repair
LAMP SWITCH - BRAKE PEDAL POSITION
REMOVAL
1. Disconnect the battery ground cable.
2. Disconnect the brake pedal position (BPP) switch electrical connector.
3. Remove the BPP switch.
1
Remove the self-locking pin.
2
Remove the brake master cylinder push rod spacer.
3
Remove the BPP switch from the brake master cylinder push rod.
4
Remove the brake master cylinder push rod bushing.
5
Remove the brake master cylinder push rod spacer.
INSTALLATION
1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
To install, reverse the removal procedure.