Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
2. Place the rocker arm pedestal on the steel ball, and the rocker arm.
3. Snap the retaining clip over the rocker arm pedestal groove.
4. Lubricate the push rod ends with engine oil and install the push rod, copper end up.
5. CAUTION: Make sure to follow the next step of this procedure to prevent bent valves.
Rotate the engine until the mark on the crankshaft damper is at 11 o'clock, to prevent damage when installing the intake rocker arm and exhaust
rocker arm.
6. NOTE: Both the left and right side rocker arms and push rods are installed the same way. Only the left side is shown.
Install the eight push rods, the eight rocker arms and the 16 rocker arm bolts.
7. Install the valve cover.
8. Raise and support the vehicle.
