ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Bag System Reconnect Checklist|Page 1944 > < Air Bag System Reconnect Checklist
Page 1
background image

Air Bag(s) Arming and Disarming: Service and Repair
Prove Out Procedure

Prove Out Procedure

Turn the ignition switch from the OFF to the RUN position and visually monitor the air bag indicator with the air bag modules and belt and buckle
assembly pretensioners installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air bag
Supplemental Restraint System (SRS) fault is present, the air bag indicator will either:

^

fail to light.

^

remain lit continuously.

^

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the RUN position. This is the
time required for the air bag Electronic Crash Sensor (ECS) module to complete the testing of the SRS. If the air bag indicator is inoperative and an SRS
fault exists, a chime will sound in a pattern of five sets of five beeps, or a buzzer will sound for five-seconds-on and five-seconds-off. If this occurs, the
air bag indicator will need to be repaired before diagnosis can continue.

Air Bag System Reconnect Checklist|Page 1944 > < Air Bag System Reconnect Checklist