Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
6. Remove the evaporative emission canister vent solenoid.
NOTE:
^
Inspect and install new O-ring seals as necessary.
^
A twisting and pulling motion is necessary to remove the evaporative emission canister vent solenoid.
7. Remove the evaporative emission canister outlet elbow.
NOTE:
^
Inspect and install new O-ring seals as necessary.
^
A twisting and pulling motion is necessary to remove the inlet fitting.
8. Remove the Evaporative Emission (EVAP) canister.
1
Remove the bolt and mounting bracket.
2
Remove the evaporative emission canister.
INSTALLATION
1. To install, reverse the removal procedure.
^
Carry out the evaporative emission system leak test. See: Testing and Inspection/Component Tests and General Diagnostics/Evaporative
Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission Repair Verification Drive Cycle
NOTE: Lubricate the O-ring seals with MERPOL(R) O-Ring Seal Lubricant or equivalent meeting Ford specification ESE-M99B144-B.
