Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
Seat Belt Height Adjuster: Service and Repair
General Procedures
D-Ring Installation Kit
SPECIAL TOOL(S)
1. Remove the shoulder safety belt height adjuster.
2. Use the half-inch drill with integral stop provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the M14 x 1.5 tap with integral stop provided in the D-Ring Installation Kit, and tap new threads.
NOTE: After each rotation, back off the tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
4. Use a threaded insert (part no. N807170-S190) provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below
the surface.
