Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
Driver seat only
2. Remove the front seat back latch lower cover.
Passenger seat only
3. Remove the front seat back pivot side outer cover.
All vehicles
4. Remove the safety belt buckle and pretensioner.
1
Disconnect the safety belt buckle and pretensioner harness connector.
2
Using the Safety Belt Bolt Torx Bit, remove the safety belt buckle and pretensioner bolt.
3
Remove the safety belt buckle and pretensioner.
NOTE: The driver side is shown, the passenger side is similar.
INSTALLATION
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS AND
NOTES AT THE BEGINNING OF THE REMOVAL PROCEDURE.
1. Install the safety belt buckle and pretensioner.
1
Position the safety belt buckle and pretensioner to the seat.
2
Install the bolt.
3
Connect the electrical connector.
2. Install the seat side shield.
NOTE: The driver side is shown, the passenger side is similar.
3. Restore the vehicle to operating condition.
1
Install the seat with the affected safety belt buckle and pretensioner.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES, AND INSTRUCTIONS IN THE SEAT REMOVAL AND INSTALLATION PROCEDURE.
2
Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, NOTES,
AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION/REACTIVATION,
PROCEDURE. Refer to Air Bag(s) Arming and Disarming.
