Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
4. Remove the tie rod end.
1
Loosen the bolts on the tie rod adjusting sleeve clamp.
2
Count the number of turns required to remove the tie rod end from the tie rod adjusting sleeve clamp.
Installation
1. Install the tie rod end.
^
Turn the tie rod end into the tie rod adjusting sleeve clamp approximately the same number of turns used to remove old tie rod end. This will
provide an approximate toe-in setting.
2. Tighten the tie rod adjusting sleeve clamp.
3. Install the ball stud in the front wheel spindle, then tighten the castle nut.
4. Install a new cotter pin.
5. Check toe-in.