ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Transmission Fluid Cooler Tubes - 4R100 Transmission|Page 4167 > < Transmission Fluid Cooler Tubes - 4R100 Transmission
Page 2
background image

2. Tighten the cooler tube fitting(s).

3. CAUTION:  Install a new inline transmission fluid filter (XC3Z-7B155-BA) every 48,000 km (30,000 miles) and always as part of a transmission

overhaul or exchange. If the vehicle was not equipped with an inline fluid filter install a new inline transmission fluid filter kit (XCJZ-7B155-AA)
according to the instructions supplied with the kit as part of a transmission overhaul or exchange.

CAUTION:  Failure to follow the instructions supplied with the inline transmission fluid filter kit can cause transmission damage.

CAUTION:  Verify that the flow arrow on the filter points toward the transmission.

Install a new inline transmission fluid filter (XC3Z-7B155-BA). If the vehicle was not equipped with an inline fluid filter, install a new inline
transmission fluid filter kit (XC3Z-7B155-AA) according to the instructions supplied with the kit. Carry out the transmission fluid cooler flow test
procedure to verify that there is correct fluid flow through the new inline fluid filter. 

4. Lower the vehicle.

5. CAUTION: Using a fluid rated for MERCON V may cause internal damage in MERCON only applications.

MERCON(R) Automatic Transmission Fluid is being replaced by MERCON(R) V as a service fluid, per TSB 06-14-4.

Fill the transmission with the specified type and quantity of transmission fluid. 
-

Use Motorcraft MERCON V Multi-Purpose (ATF) Transmission Fluid XT-5-QM or equivalent meeting MERCON V specifications.

6. Check for leaks.

Transmission Fluid Cooler Tubes - 4R100 Transmission|Page 4167 > < Transmission Fluid Cooler Tubes - 4R100 Transmission