Econoline E550 V8-7.3L DSL Turbo VIN F (2002)
7. Using a soft-faced hammer and the special tool, drive the pinion assembly out of the front bearing cone and remove it through the rear of the
housing.
-
Remove the rear axle drive pinion seal.
-
Remove the rear axle drive pinion shaft oil slinger.
8. NOTE: Remove the collapsible spacer and discard it.
Using the special tool, remove the pinion bearing.
9. NOTE: Do not remove the pinion bearing cups from the housing unless the cups are damaged.
Using the special tools, remove the outer differential bearing cup.
10. Using the special tools, remove the inner differential bearing cup.
Installation