Edge AWD V6-3.5L (2009)
Communications Control Module: Removal and Replacement
Audio Digital Signal Processing (DSP) Module
Audio Digital Signal Processing (DSP) Module
Removal and Installation
1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation
(PMI) in Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming
and Relearning
2. Remove the subwoofer speaker. For additional information, refer to Speaker - Subwoofer See: Radio, Stereo, and Compact Disc/Speaker/Service
and Repair/Speaker - Subwoofer.
3. Disconnect the audio DSP module electrical connectors.
4. Remove the 3 screws, the nut, and the audio DSP module.
5. To install, reverse the removal procedure.
-
Download the configuration information to the audio DSP module. For additional information, refer to PMI in Information Bus. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
Audio Control Module (ACM)
Audio Control Module (ACM)