Edge AWD V6-3.5L (2009)
Removal and Installation
1. Remove the floor console.
2. Remove the floor console rear trim panel by pulling straight rearward to disengage the clips.
3. Disconnect the Universal Serial Bus (USB) cable-to-Accessory Protocol Interface Module (APIM) connector.
4. Disconnect the USB cable-to-bezel connector.
-
Disengage the push-pin near the connection.
5. Disconnect the USB cable-to-bezel connector.
6. Remove the 3 screws holding the front of the RH panel to the floor console.
7. Remove the 2 screws and the APIM and bracket as an assembly.
-
Disconnect the electrical connector.
8. Remove the screw holding the upper rear of the RH panel to the floor console.
