Edge AWD V6-3.5L (2009)
Yes
REFER to Charging System.
No
GO to C3.
-------------------------------------------------
C3 CHECK THE BATTERY CONDITION AND STATE OF CHARGE
-
Ignition OFF.
-
Check the battery condition and verify the battery is fully charged. Refer to Battery.
-
Is the battery OK and fully charged?
Yes
GO to C4.
No
REFER to Charging System.
-------------------------------------------------
C4 CHECK THE DSM VOLTAGE SUPPLY
-
Measure and record the voltage at the battery.
-
Disconnect: DSM C341A.
-
Ignition ON.
-
Measure the voltage between the DSM C341A-1, circuit SBB45 (GY/RD), harness side and ground.
-
Is the voltage within 0.2 volt of the recorded battery voltage?
Yes
GO to C5.
No
REPAIR the circuit for high resistance. CLEAR the DTC. REPEAT the self-test.
-------------------------------------------------
C5 CHECK THE DSM GROUND CIRCUIT
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the DSM C341A-2, circuit GD143 (BK/VT), harness side and ground.
