Edge AWD V6-3.5L (2009)
menu. This avoids an additional security access procedure and the associated 10 minute time delay.
1. Turn the key from the OFF position to the ON position.
2. From the scan tool, enter TOOLBOX. Select BODY-SECURITY-PATS Functions and follow the on-screen instructions to ENTER SECURITY
ACCESS. For additional information, refer to Anti-Theft Security Access See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Testing and Inspection/Component Tests and General Diagnostics.
3. From the scan tool, select: Parameter Reset and follow the IDS on-screen instructions.
4. NOTE: If the IC was replaced, follow Steps 4-9. If the IC and the PCM were replaced, follow Steps 4-9. If only the PCM was replaced, cycle the
key off, then back on, to complete the procedure.
NOTE: If steps 4-9 are followed, 2 keys must be present.
From the scan tool, select: Ignition Key Code Erase and follow the IDS on-screen instructions.
5. Turn the key to the OFF position and disconnect the scan tool.
6. NOTE: Integrated Keyhead Transmitter (IKT) keys require a 6-second programming time frame for the Remote Keyless Entry (RKE) data
transfer to take place, while standard Passive Anti-Theft System (PATS) keys only require a minimum of 3 seconds.
Turn the key to the ON position for a minimum of 6 seconds (if it is an IKT key).
7. Turn the key to the OFF position and remove it from the ignition lock cylinder.
8. Insert the second key and turn it to the ON position for a minimum of 6 seconds (if it is an IKT key).
9. Both keys will now start the vehicle and will also operate the RKE functions of the vehicle (if they are IKT keys).
10. NOTE: The RKE data transfer will take place between the key and the IC first. After both keys are programmed into the IC, the RKE data will
transfer from the IC to the Smart Junction Box (SJB). Until the final data transfer takes place into the SJB, the RKE functions will not operate.
If more keys are required to be programmed, refer to Key Programming Using Two Programmed Keys See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Key Programming Using Two Programmed Keys.
