Edge AWD V6-3.5L (2009)
3. Turn the ignition switch from the ON to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition switch to the ON position. The horn chirps once to indicate that programming mode is entered.
6. NOTE: The unlock button must be pressed twice within 5 seconds.
Within 30 seconds of entering the programming mode, press the unlock button on the door lock control switch twice to enable/disable the
perimeter lighting feature. The horn chirps once if the perimeter lighting is disabled or a chirp followed by a honk if the perimeter lighting is
enabled.
7. Programming ends when the ignition switch state changes or times out after 2 minutes.
Stepped Unlock Programming
Stepped Unlock Programming
1. With the ignition switch in the OFF position, press the LOCK and UNLOCK buttons on the Remote Keyless Entry (RKE) transmitter
simultaneously for 4 seconds.
-
The turn signals flash twice to indicate the mode change.
2. Repeat Step 1 to enable/disable the stepped unlocking feature.