Edge AWD V6-3.5L (2009)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Rear Seat
Heated Seat Module - Rear Seat
Removal and Installation
WARNING: Never install heated seat parts not intended for use on this vehicle. Parts released for other model years or vehicle lines are not
compatible even if they appear visually and physically similar. Installing incorrect parts will result in heated seat system performance outside
design specification. Failure to follow this instruction may result in serious personal injury.
1. Remove the second row 60 percent seat front riser-to-floor nut and bolt.
-
To install, tighten to 70 Nm (52 lb-ft).
2. Pivot the front of the 60 percent seat cushion upward.
3. Remove the screw, disconnect the electrical connector and remove the heated seat module.
4. To install, reverse the removal procedure.