Edge AWD V6-3.5L (2009)
Remove the LH and RH rear 12 front track-to-housing screws.
9. NOTE: LH shown, RH similar.
Remove the LH and RH rear drive tube bracket-to-housing screws.
10. NOTE: Carefully mark the location of each shade track in 3 places before removing any fasteners. The shade tracks must be installed in exactly
the same position.
NOTE: LH shown, RH similar.
NOTE: Support the shade track and shade motor block and tube assembly.
Remove the LH and RH 6 rear shade track-to-housing screws.
11. NOTE: Protect the vehicle interior from cable grease.
Carefully pull the sliding glass front drive tube brackets out of the guide tracks.
12. NOTE: It is only necessary to pull the mechanisms halfway out of the guide tracks to disengage the cables. If the mechanisms are completely
removed from the track, they will need to be reassembled first. For additional information, refer to Roof Opening Panel - Exploded View See:
Sunroof / Moonroof Panel/Service and Repair/Roof Opening Panel - Exploded View.
NOTE: LH shown, RH similar.
With the rear of the front guide tracks lowered, carefully pull the front sliding glass mechanisms halfway out of the guide tracks to disconnect the
drive cables and remove the motor block and tube assembly.
Installation
1. NOTE: LH shown, RH similar.
