Edge AWD V6-3.5L (2009)
Seat Back: Removal and Replacement
Seat Backrest - Front
Seat Backrest - Front
Removal
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the front seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
2. Remove the cushion side shield in the following sequence.
1. If equipped, release the clip and remove the manual recline handle.
2. If equipped, pull and remove the manual height adjust handle.
3. If equipped, remove the manual lumbar handle.
-
Adjust the manual lumbar until fully relaxed and release the 2 clips behind the manual lumbar handle and remove.
4. Remove the cushion side shield screw(s).
5. For power seat, slide the cushion side shield up in the rear to release the retainer.
6. Slide the cushion side shield forward to disengage the retainer and remove the cushion side shield.
-
If equipped, disconnect the seat control switch electrical connector.
3. Remove the screw, scrivet and recliner side shield.
4. If equipped, remove the manual lumbar cable from the manual lumbar adjuster in the following sequence.
1. Remove the manual lumbar adjuster bracket screw.
2. Separate the manual lumbar adjuster from the bracket.
3. Remove the manual lumbar cable from the manual lumbar adjuster.
Passenger seat with fold-flat backrest
5. Separate the recliner cable casing and Z-fitting from the LH fold-flat recliner.
6. Separate the recliner cable casing and Z-fitting from the RH fold-flat recliner.
