Edge AWD V6-3.5L (2009)
7. Pull out and remove the 2 head restraint guides.
-
Discard the slave head restraint guide.
-
For assembly, install a new slave head restraint guide.
8. NOTICE: When installing, make sure the side air bag module wiring harness is not pinched between the side air bag module and the
backrest frame or damage to the wiring harness can occur.
NOTE: When installing the side air bag module, new bolts must be installed.
Remove the side air bag module.
1. Remove and discard the 2 side air bag module bolts.
-
For assembly, install 2 new bolts and tighten to 23 Nm (17 lb-ft).
2. Remove the side air bag module with wire harness.
-
Detach any side air bag module wire harness retainers.
9. NOTICE: Use care when separating the backrest trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from
the backrest foam pad.
NOTE: A new heater mat will come attached on a new foam pad.
Remove the backrest trim cover.
-
Invert the backrest trim cover in an inside out fashion to the wire in the backrest trim cover attached to the clips in the backrest foam pad.
-
Separate the hook-and-loop strips.
-
Separate the backrest trim cover wire from the clips in the backrest foam pad.
-
If equipped, feed out the backrest heater mat wire harness from the opening in the side of the backrest trim cover.
-
Remove the backrest trim cover.
10. Separate the backrest frame from the backrest foam pad.
11. To assemble, reverse the disassembly procedure.
Seat Backrest - Rear, 60 Percent
Seat Backrest - Rear, 60 Percent
Rear Seat Backrest, 60 Percent
NOTE: A new heater mat will come assembled on a new foam pad.
