Edge AWD V6-3.5L (2009)
Seat Backrest Cover - Front, Without Fold Flat
Seat Backrest Cover - Front, Without Fold Flat
Removal and Installation
WARNING: Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the
body. Do not set a live air bag module down with the deployment door/trim cover/tear seam face down. Failure to follow these instructions may
result in serious personal injury in the event of an accidental deployment.
WARNING: If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install
a new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the seat side
air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
WARNING: Front seat backrest trim covers installed on seats equipped with seat side air bags cannot be repaired. A new trim cover must be
installed. Cleaning is permissible. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and
increase the risk of serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the front seat. For additional information, refer to Seat - Front See: Service and Repair/Front Seats/Seat - Front.
2. NOTE: The seat backrest trim cover and foam pad have been removed to show the backrest trim panel retainers.
Remove the backrest trim panel.
1. Release the 2 pin-type retainers at the bottom of the backrest trim panel.
2. Slide the backrest trim panel down to release the upper clips.
3. Turn the backrest trim panel to release the middle clips and remove the backrest trim panel.
3. NOTE: Lower outer J-clips are unfastened to show inner J-clips.
Release the backrest trim cover outer and inner J-clips.
