ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Front Seats|Page 8010 > < Front Seats|Page 8008
Page 15
background image

1. Invert the backrest trim cover in an inside out fashion to the wire in the backrest trim cover attached to the clips in the backrest foam pad.

2. Separate the backrest trim cover wire from the clips in the backrest foam pad.

3. If equipped, feed out the backrest heater mat and side air bag module wire harness from the opening in the side of the backrest trim cover.

4. Remove the backrest trim cover.

15. To install, reverse the removal procedure.

-

For correct front passenger seat cushion wire harness routing at installation, refer to Seat Wire Harness Routing - Front Passenger Cushion  
See: Service and Repair/Front Seats/Seat Wire Harness Routing - Front Passenger Cushion.

Seat Cushion Cover - Front

Seat Cushion Cover - Front

Removal and Installation

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the front seat cushion. For additional information, refer to Seat Cushion - Front  See: Seat Cushion/Service and Repair/Removal and

Replacement/Front Seats.

2. Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover and cushion foam pad.

3. NOTICE: Use care when separating the cushion trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from

the cushion foam pad.

NOTE: A new heater mat will come assembled on a new foam pad.

Remove the cushion trim cover in the following sequence.

1. Invert the cushion trim cover and separate the wire retainer from the clips in the cushion foam pad.

-

If equipped, make sure the climate controlled seat manifold is in place before snapping the cushion trim cover wire retainer back into the
cushion foam pad for correct installation.

2. Remove the cushion trim cover.

4. To install, reverse the removal procedure.

5. Install the front seat cushion. For additional information, refer to Seat Cushion - Front  See: Seat Cushion/Service and Repair/Removal and

Replacement/Front Seats.
-

For correct front passenger seat cushion wire harness routing, refer to Seat Wire Harness Routing - Front Passenger Cushion  See: Service and
Repair/Front Seats/Seat Wire Harness Routing - Front Passenger Cushion.

Front Seats|Page 8010 > < Front Seats|Page 8008