Edge AWD V6-3.5L (2009)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Front
Heated Seat Module - Front
Removal and Installation
WARNING: Never install heated seat parts not intended for use on this vehicle. Parts released for other model years or vehicle lines are not
compatible even if they appear visually and physically similar. Installing incorrect parts will result in heated seat system performance outside
design specification. Failure to follow this instruction may result in serious personal injury.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Position the front passenger seat to access the heated seat module.
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and
Repowering in the General Procedures portion of Air Bag Systems.
3. Remove the heated seat module.
-
For power seat track, remove the 2 screws and lower the bracket.
-
Disconnect the heated seat module electrical connector.
-
Remove the screw and heated seat module.
4. To install, reverse the removal procedure.
5. Repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering
and Repowering in the General Procedures portion of Air Bag Systems.
6. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test. For additional information, refer to the General Procedures
portion of Air Bag Systems. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Component Tests and General Diagnostics
