Edge AWD V6-3.5L (2009)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
NOTICE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these
charges.
NOTICE: Do not allow any brake fluid or foreign material to enter the mating side of the Anti-lock Brake System (ABS) module or damage to
the solenoids can occur.
1. Remove the Hydraulic Control Unit (HCU). For additional information, refer to Hydraulic Control Unit (HCU) See: Hydraulic Control Assembly
- Antilock Brakes/Service and Repair.
2. Remove the 4 ABS module screws and the ABS module.
-
To install, tighten to 5 Nm (44 lb-in).
3. NOTE: Visually inspect the ABS module terminals for damage before installation.
To install, reverse the removal procedure.
-
Carry out the IVD Initialization sequence. Follow the scan tool directions.