Edge AWD V6-3.5L (2009)
4. Remove the brake caliper.
5. NOTE: During installation, make sure that the brake caliper hose is not twisted.
To install, reverse the removal procedure.
-
Bleed the brake caliper.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal and Installation
1. Remove the wheel and tire.
2. NOTICE: Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.
NOTICE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
-
Support the caliper using mechanic's wire.
-
To install, tighten to 88 Nm (65 lb-ft).
3. Remove the brake pads and the stainless steel shims.
4. Remove the brake pad slides.
5. Remove the 2 brake caliper anchor plate bolts and the anchor plate.
-
To install, tighten the new bolts to 133 Nm (98 lb-ft).
6. To install, reverse the removal procedure.
-
Apply brakes several times to verify correct brake operation.
