Edge AWD V6-3.5L (2009)
-
Support the caliper using mechanic's wire.
4. Remove the 2 brake pads, shims and slide clips.
-
Discard the slide clips.
Installation
1. NOTICE: Protect the caliper pistons and boots when pushing the caliper piston into the caliper piston bores or damage to components
may occur.
NOTE: Make sure the caliper piston boot is clean and free of foreign material.
If installing new brake pads, using a suitable tool and a worn brake pad, compress the disc brake caliper pistons into the caliper.
2. Install the 2 brake pads, shims and new slide clips to the brake caliper anchor plate.
3. NOTICE: Make sure that the caliper guide pin boots are fully seated or damage to the caliper guide pin boots can occur.
NOTE: Make sure that the brake caliper hose is not twisted during caliper installation.
Position the brake caliper on the anchor plate and install the 2 guide pin bolts.
-
Tighten to 26 Nm (19 lb-ft).
4. Install the wheel and tire.
5. Fill the brake master cylinder reservoir with clean, specified brake fluid.
-
Apply brakes several times to verify correct brake operation.
