Edge AWD V6-3.5L (2009)
3. Disconnect the LH parking brake cable from the equalizer.
4. Squeeze the tabs and disconnect the LH parking brake cable from the bracket.
All-Wheel Drive (AWD) vehicles
5. Remove the wheel speed sensor bolt and position the wheel speed sensor aside.
-
To install, tighten to 7 Nm (62 lb-in).
All vehicles
6. Remove the 2 parking brake cable-to-support plate bolts and disconnect the cable from the lever.
-
To install, tighten to 23 Nm (17 lb-ft).
7. Remove the stabilizer bar link nut and position the stabilizer bar link aside.
-
To install, tighten to 35 Nm (26 lb-ft).
8. Remove the parking brake cable front bracket bolt, middle bracket bolt and the parking brake cable.
-
To install, tighten to 23 Nm (17 lb-ft).
9. To install, reverse the removal procedure.
-
Adjust the parking brake cable. For additional information, refer to Parking Brake Cable Adjustment See: Adjustments.
