Edge AWD V6-3.5L (2009)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
Removal and Installation
1. Remove the wheel and tire.
2. Remove the retainers and position the fender splash shield aside.
3. Disconnect the wheel speed sensor electrical connector.
4. Disconnect the 6 pushpin fasteners.
5. Remove the front wheel speed sensor bolt and the wheel speed sensor.
-
To install, tighten to 7 Nm (62 lb-in).
6. NOTICE: The wheel speed sensor harness must be routed as shown or damage to the harness during vehicle jounce and rebound can
occur.
To install, reverse the removal procedure.