Edge AWD V6-3.5L (2009)
NOTE:
Before starting this service procedure make sure that you have the equipment listed.
NOTE:
The dealer bulletin contains the parts list for this service procedure (see Attachment II)
Necessary equipment for the cooling system flush:
1. Rotunda Tool Kit #303-1525
2. Two large radiator hose pinch-off pliers (not supplied with the tool kit)
3. One clean 5 gallon bucket (not supplied with the tool kit)
4. An infrared thermometer or equivalent (not supplied with the tool kit)
5. Safety equipment (eye protection and chemical gloves, not supplied with the tool kit)
6. AirLift Cooling Tester UVU-550000 (not shown, formerly Radkit Plus)
7. Shop water supply hose (not shown)
8. Radiator drain pan (not shown)
WATER PUMP INLET TUBE
NOTE:
Dispose of old coolant in accordance with local state and federal laws.
NOTE:
On some of the affected vehicles the water pump inlet tube is painted on the inside surface. The flushing chemicals will remove the paint and
contaminate the cooling system and components.
1. Place a drain pan under the radiator drain valve and completely drain the cooling system through the radiator drain (degas bottle cap should be loose
for proper draining).
2. Remove the air cleaner as an assembly.
^
Disconnect the mass air flow (MAF) sensor electrical connector.
^
Loosen the clamp and disconnect the air cleaner assembly outlet pipe from the air cleaner assembly.
^
Remove the air cleaner assembly bolts.
