Edge AWD V6-3.5L (2009)
4. Remove the coolant hoses from the thermostat housing. See Figure 2.
5. Remove the 3 thermostat housing bolts.
6. Separate the thermostat housing from the water pump inlet tube.
7. NOTE: The water pump inlet tube orientation can be determined by the length of the radius at the ends of the tube The longer radius end is Inserted
Into the water pump housing. See Figure 3.
Remove the water pump inlet tube from the water pump housing using a slight twisting motion The inlet tube must be replaced with a new inlet tube
without paint on the interior surface of the tube.
8. Lubricate the new water pump inlet tube O-ring with clean engine coolant.