Edge AWD V6-3.5L (2009)
Valve Cover - LH (View 2 of 2)
Removal
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while
cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
1. Remove the crankcase vent tube.
2. Remove the LH ignition coils.
3. Remove the oil level indicator.
4. Disconnect the LH Variable Camshaft Timing (VCT) solenoid electrical connector.
5. Detach all of the wiring harness retainers from the valve cover and the stud bolts.
6. Loosen the 11 stud bolts and remove the LH valve cover.
-
Discard the gasket.
7. NOTE: VCT solenoid seal removal shown, spark plug tube seal removal similar.
Inspect the VCT solenoid seals and the spark plug tube seals. Remove any damaged seals.
-
Using the VCT Spark Plug Tube Seal Remover and Handle, remove the seal(s).
