Edge AWD V6-3.5L (2009)
22. Connect the purge valve electrical connector.
23. Install the radio interference capacitor, the ground wire and the nut to the cowl stud.
-
Tighten to 10 Nm (89 lb-in).
24. Install the radio interference capacitor wire, the ground wire and the nut to the engine front cover stud.
-
Tighten to 10 Nm (89 lb-in).
25. Install the ground wire and bolt on the engine front cover.
-
Tighten to 10 Nm (89 lb-in).
26. Connect the 2 engine wiring harness connectors.
27. Using a new O-ring seal, connect the A/C pressure tube fitting and install the nut.
-
Tighten to 8 Nm (71 lb-in).