Edge AWD V6-3.5L (2009)
-
Install the drain plug and tighten to 27 Nm (20 lb-ft).
16. If equipped, detach the engine block heater harness from the radiator support, the A/C suction tube and the engine wiring harness.
17. Remove the engine Air Cleaner (ACL) and ACL outlet pipe.
18. Remove the LH and RH valve covers. For additional information, refer to Valve Cover - LH See: Cylinder Head Assembly/Valve Cover/Service
and Repair/Valve Cover - LH and Valve Cover - RH See: Cylinder Head Assembly/Valve Cover/Service and Repair/Valve Cover - RH.
19. Remove the safety clip from the A/C suction tube fitting.
-
Disconnect the A/C suction tube fitting and position the tube aside.
20. Remove the A/C pressure tube bracket bolt.
21. Remove the nut and disconnect the A/C pressure tube fitting.
-
Discard the O-ring seal.
-
Position the A/C pressure tube aside.
22. Disconnect the 2 engine wiring harness connectors.
