Edge AWD V6-3.5L (2009)
38. NOTE: Only use hand tools to remove the studs.
Remove the 2 engine mount studs.
39. Remove the 2 upper engine mount bracket bolts.
40. Lower the engine to access the lower engine mount bracket bolt.
41. Loosen the lower engine mount bracket bolt and remove the engine mount bracket and bolt as an assembly.
42. Remove the 22 engine front cover bolts.
43. Install 6 of the engine front cover bolts (finger tight) into the 6 threaded holes in the engine front cover.
-
Tighten the bolts one turn at a time in a criss-cross pattern until the engine front cover-to-cylinder block seal is released.
-
Remove the engine front cover.
