Edge AWD V6-3.5L (2009)
40. Connect shop air supply to the tool kit pump. The pump will start to siphon the Motorcraft(R) Engine Cooling System Cleaner VC-11 from the
bucket into the engine.
41. NOTICE:
With the heater in the OFF position start the engine and idle until the Motorcraft(R) Engine Cooling System Cleaner VC-11/water mixture
temperature reaches 140° F (60° C) Monitor the Motorcraft(R) Engine Cooling System Cleaner VC-11/water mixture temperature using an
infrared thermometer or equivalent in the flush tool kit bucket.
42. When the Motorcraft(R) Engine Cooling System Cleaner VC-11/water mixture temperature reaches 140° F (60° C) remove the pinch-off pliers
from the upper radiator hose.
43. Disconnect the A/C high pressure cut-off switch electrical connector This will activate the engine cooling fans. It may take a few seconds until the
cooling fans come on See Figure 14.
44.
NOTICE:
Make sure that the radiator is NOT obstructed for maximum air flow Any deflection of air may cause an overheating condition.
NOTICE:
The Motorcraft(R) Engine Cooling System Cleaner VC11/water mixture temperature MUST NOT EXCEED 15° F (65° C) or damage to the
