Edge AWD V6-3.5L (2009)
Refrigerant Oil: Service and Repair
Refrigerant Oil Adding
Refrigerant Oil Adding
NOTICE: During normal Air Conditioning (A/C) operation, oil is circulated through the system with the refrigerant, and a small amount is
retained in each component. If certain components of the system are removed, some of the refrigerant oil will go with the component. To
maintain the original total oil charge, it is necessary to compensate for the oil lost by adding oil to the system with the new part.
1. Refer to the chart below for refrigerant oil adding amounts and methods of installation.
a If an excessive amount of refrigerant oil is lost due to a hose rupture/separation or other damage, the total system refrigerant oil capacity must be
added.
b The amount specified may be used for one or multiple O-ring leak repairs. Do not multiply the refrigerant oil amount by the number of O-ring leaks
being repaired.
Refrigerant Oil Adding for New A/C Compressor Installation
Service A/C compressors shipped without clutch and pulley
1. Rotate the A/C compressor shaft 6 to 8 revolutions while collecting oil in a clean measuring device.
-
If the amount of oil drained from the old A/C compressor is between 85-142 ml (3-5 oz), pour the same amount plus 30 ml (1 oz) of clean
PAG Refrigerant Compressor Oil (R-134a Systems) (YN-12-D) WSH M1C231-B or equivalent into the new A/C compressor.
-
If the amount of oil that was removed from the old A/C compressor is greater than 142 ml (5 oz), pour the same amount drained of clean PAG
Refrigerant Compressor Oil (R-134a Systems) or equivalent into the new A/C compressor.
