Edge AWD V6-3.5L (2009)
Fuel Level Sensor: Service and Repair
Fuel Level Sender
Fuel Level Sender
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be
ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
1. Remove the Fuel Pump (FP) module. For additional information, refer to Fuel Pump Module See: Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Fuel Pump Module.
2. Disconnect the fuel level sender electrical connector.
3. Depress the lock tab and slide the fuel level sender upwards and remove.
