ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3076 > < Initial Inspection and Diagnostic Overview|Page 3074
Page 63
background image

-------------------------------------------------
U31 VERIFY VEHICLE EQUIPMENT - HVAC MODULE

-

Inspect the vehicle for an HVAC module.

-

Is the vehicle equipped with an HVAC module?

Yes

GO to U32.

No

GO to U33.

-------------------------------------------------
U32 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE HVAC MODULE
DISCONNECTED

-

Disconnect: HVAC Module C228a.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to U47.

No

GO to U33.

-------------------------------------------------
U33 VERIFY VEHICLE EQUIPMENT - LTM

-

Inspect the vehicle for a Liftgate/Trunk Module (LTM).

-

Is the vehicle equipped with an LTM?

Yes

GO to U34.

No

GO to U35.

-------------------------------------------------
U34 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE LTM DISCONNECTED

-

Disconnect: LTM C4174b.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

Initial Inspection and Diagnostic Overview|Page 3076 > < Initial Inspection and Diagnostic Overview|Page 3074