Edge AWD V6-3.5L (2009)
-
Is the voltage greater than 6 volts?
Yes
REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
GO to V5.
-------------------------------------------------
V5 CHECK FOR RESTORED COMMUNICATION WITH THE PCM DISABLED
-
Disconnect: Battery Junction Box (BJB) Fuses 21 (7.5A), 30 (15A) and 49 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test A. See: Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to V6.
-------------------------------------------------
V6 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE DISABLED
-
Disconnect: BJB Fuse 50 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test B. See: Pinpoint Test B: The ABS Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to V7.
-------------------------------------------------
V7 VERIFY VEHICLE EQUIPMENT - 4X4 CONTROL MODULE
-
Inspect the vehicle for a 4X4 control module.
-
Is the vehicle equipped with a 4X4 control module?
Yes
GO to V8.
No
GO to V9.
-------------------------------------------------
V8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE 4X4 CONTROL MODULE DISABLED
-
Disconnect: BJB Fuses 11 (10A) and 35 (20A).
