ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3094 > < Initial Inspection and Diagnostic Overview|Page 3092
Page 81
background image

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a 4X4 control module, GO to W14.

If the vehicle is not equipped with a 4X4 control module, GO to W15.

No

CONNECT the negative battery cable. GO to W31.

-------------------------------------------------
W14 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE 4X4 CONTROL MODULE
DISCONNECTED

-

Disconnect: 4X4 Control Module C281.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to W15.

No

CONNECT the negative battery cable. GO to W32.

-------------------------------------------------
W15 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE RCM DISCONNECTED

-

Disconnect: RCM C310b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a Steering Angle Sensor Module (SASM), GO to W16.

If the vehicle is not equipped with an SASM, GO to W17.

No

Initial Inspection and Diagnostic Overview|Page 3094 > < Initial Inspection and Diagnostic Overview|Page 3092