Edge AWD V6-3.5L (2009)
Yes
INSTALL a new PCM. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
W30 CHECK FOR CORRECT HCM OPERATION
-
Disconnect all the HCM connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the HCM connectors and make sure they seat correctly.
-
Verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new HCM. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
W31 CHECK FOR CORRECT ABS MODULE OPERATION
-
Disconnect the ABS module connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the ABS module connector and make sure it seats correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new ABS module. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
W32 CHECK FOR CORRECT 4X4 CONTROL MODULE OPERATION
-
Disconnect all the 4X4 control module connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the all 4X4 control module connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
