Edge AWD V6-3.5L (2009)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Removal and Installation
RH sensor
1. Remove the Air Cleaner (ACL) outlet pipe.
LH sensor
2. Remove the ACL assembly.
Both sensors
3. Disconnect the Camshaft Position (CMP) electrical connector.
4. Remove the bolt and the CMP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
5. NOTE: Lubricate the CMP O-ring seal with clean engine oil.
To install, reverse the removal procedure.
