Edge AWD V6-3.5L (2009)
Canister Purge Control Valve: Service and Repair
Evaporative Emission Canister Purge Valve
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
1. Disconnect the battery ground cable.
2. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
3. Disconnect the 2 vapor tube-to-EVAP canister purge valve quick connect couplings.
4. Depress the tab and remove the EVAP canister purge valve from the bracket.
5. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Testing and Inspection.
