Edge AWD V6-3.5L (2009)
2. Disconnect the battery ground cable.
3. Remove the 3 bolts, pin-type retainer and the EVAP shield.
-
To install, tighten to 9 Nm (80 lb-in).
4. Disconnect the EVAP canister vent solenoid electrical connector.
5. Disconnect the fuel vapor tube-to-EVAP canister quick connect coupling.
6. Disconnect the fuel vapor tube assembly-to-EVAP canister quick connect coupling.
7. Disconnect the fuel vapor tube to the dust separator.
8. Remove the 3 EVAP canister bolts.
-
To install, tighten to 9 Nm (80 lb-in).
9. Release the pin-type retainer and remove the EVAP canister.
10. NOTE: When installing the EVAP canister, insert the alignment tab into the body first, then install the pin-type retainer and 3 bolts.
To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
Testing and Inspection.
