Edge AWD V6-3.5L (2009)
Installation
1. Install the TR sensor.
1. Position the park pawl actuating rod in the TR sensor.
2. Install the TR sensor in the transaxle case.
2. Using the Manual Lever Retaining Pin Installer, install a new TR sensor locking pin.
3. NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
4. Inspect the manual pin to make sure it is correctly installed in the manual control valve. If it is not, pull the valve body off the transaxle case.
