Edge AWD V6-3.5L (2009)
14. Position the transmission fluid cooler thermal bypass valve and transmission fluid cooler tube assembly in place and install the 2 transmission fluid
cooler tube bracket nuts.
-
Tighten to 9 Nm (80 lb-in).
15. Connect the transaxle electrical connector.
16. NOTICE: Make sure that when installing the manual control lever it is fully seated onto the manual control lever shaft or damage to the
manual control lever shaft will occur and the lever will come loose.
NOTICE: Make sure to hold the manual control lever while tightening the manual control lever nut or damage to the manual control
lever and park components will occur.
Install the manual control lever and the nut.
-
Tighten to 18 Nm (159 lb-in).
17. Inspect the transmission fluid cooler tube backing ring and seal for damage and install a new backing ring or seal if necessary. Lubricate the
transmission fluid cooler tube seal with clean transmission fluid and install the backing ring and seal on the transmission fluid cooler tube.