Edge AWD V6-3.5L (2009)
NOTE: Carrying out Programmable Module Installation (PMI) will not enable the 911 assist option that is disabled. The RCM and Accessory Protocol
Interface Module (APIM) must be configured correctly to fully support 911 assist functionality.
1. When installing a new RCM, carry out the appropriate steps necessary for the Programmable Module Installation (PMI) procedure. See:
Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint
System (SRS) Depowering and Repowering.
3. Remove the floor console.
4. Disconnect the selector lever cable from the ball stud located on the shifter and remove the cable from the retaining clips.
5. Remove the 4 bolts (2 each side) from the inner floor console support.
6. Remove the bolts from the inner floor console support-to-instrument panel.
7. Disconnect the electrical connectors from the front inner floor console support.
8. Remove the floor console.
9. Press to release the locking tab and disconnect the small RCM electrical connector.
10. Disconnect the large RCM electrical connector.
1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
2. Pull out and disconnect the RCM electrical connector.
11. Remove the 3 bolts and RCM.
Installation
1. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
Install the RCM and the 3 bolts.
-
Tighten to 12 Nm (106 lb-in).
