Edge AWD V6-3.5L (2009)
19. Through the glove compartment opening, remove the screw and the RH duct assembly.
20. Remove the 4 bolts and the passenger air bag module support bracket.
21. Remove the 3 nuts from the passenger air bag module.
22. NOTICE: Do not allow the passenger air bag module to hang from the wiring harness. Damage to the wiring harness and connectors may
occur.
Lower the rear of the passenger air bag module off the 3 mounting studs. Move the passenger air bag module rearward to release the 7 air bag trim
cover hooks from the instrument panel and rest the module on the cross vehicle beam.
23. Using a small screwdriver as shown, lift up and release the locking button on the LH passenger air bag module electrical connector.
24. NOTICE: Do not pull the passenger air bag module electrical connector out by the locking button. Damage to the locking button may
