Edge AWD V6-3.5L (2009)
4. NOTE: The reinforcement board and seat backrest cover rear panel can be positioned aside with the reinforcement board still inside the seat
backrest cover rear panel.
Detach the 2 pin-type retainers and position aside the seat backrest cover rear panel and reinforcement board.
5. Through the rear of the seat remove and discard the 2 side air bag module bolts. Then, separate the side air bag module from the seat backrest.
6. NOTICE: Do not pull the side air bag module electrical connector out by the locking button. Damage to the locking button may occur.
Using a small screwdriver as shown, lift up and release the locking button on the side air bag module electrical connector. With the locking button
released, remove the electrical connector and the side air bag module.
Installation
1. NOTICE: Do not install the side air bag module electrical connector by the locking button. Damage to the locking button may occur.
NOTICE: The side air bag module electrical connector locking button must be in the released position when the connector is being
installed or connector damage may occur.
NOTICE: The side air bag module electrical connector is unique and cannot be reversed when connected to the side air bag module.
Match the electrical connector key to the keyway in the side air bag module. Do not force the electrical connector into the side air bag
module. Damage to the connector or component may occur.
With the locking button released, install the side air bag module electrical connector fully into the side air bag module and seat the locking button.
2. NOTICE: Make sure the side air bag module wiring harness is not pinched between the side air bag module and the backrest frame.
Damage to wire harness may occur.
NOTE: When installing the side air bag module, new bolts must be installed.
Position the side air bag module in the seat backrest and install 2 new bolts.
